Install Fleet Pro Track - JBus

The Plug-and-Play GPS Tracker in the vehicle provides the driving data needed to use Fleet Pro. Follow the instructions in this guide to install the OBD-II with JBus cables in the vehicle.

Things to know

  • Take note of the serial number printed on the device. This serial is required later when you’re setting up your Fleet Pro.
  • Azuga is Fleet Pro’s hardware provider.


What’s in the box?  





JBus device

JBus device is shipped with the  standard cables attached.

Installation-JBus  

Based on the type of port, a JBus device can be installed through any   of the  following 

1. 16 Pin Port 

2. 6 Pin/9Pin Port 

16 Pin Port: 

Locate the Vehicle’s diagnostic port, typically it can be found below  

the steering wheel. Follow the below steps to install JBus 

Fig:1 JBus 16 Pin Port  
  Fig:2 JBus 16 Pin Port covered

1. Switch off the vehicle or the unit on which the installation is performed. 

2. Plugin the device into the diagnostic Port (Fig:1). 

3. If the port is covered by a panel/door(Fig:2), use the extension cable to install the device. Ensure the device is not protruding from the panel. 

4. Setup is initialized and power is received once the LEDs on the device start flashing. 

5. Ensure the Green LED lasts for 5 seconds, which indicates the device is ready to use.

Note: If the Red LED blinks, the installation is failed, remove the device and  repeat the same steps. 

6/9 Pin Port 

1. Plug the cable to the vehicle diagnostic port as shown below.

2. Plug the device into the other end of the cable. 

3. Ensure the Green LED on the Azuga device lasts for 5 seconds, which indicates the device is ready to use. 

Note: If the Red LED blinks, the installation is failed, remove the device and repeat the same steps. 

6/9 Pin Port- Occupied 

If the vehicle diagnostic port is occupied already, use the Y-cable to install the Azuga device. 

1. Plugin the female end of the Y-cable into the diagnostic Port. 

2. Connect the device to another end of the Y cable.

3. Ensure the Green LED on the device lasts for 5 seconds, which indicates the device is ready to use. 

Note: If the Red LED blinks, the installation is failed, remove the device and  repeat the same steps. 

Setup- Fleet Tracking  

The installed JBus device needs to be set up for fleet tracking.

Fleet Web 

1. Open Fleet Web Login and enter your Login Credentials. 

2. Devices and vehicles are already created in the portal. Vehicle names and device serial numbers are the same by default. 

Note: Vehicles(created by default) can be renamed as per your requirements.

3. Click the ADMIN tab and select Vehicles. 

4. Click the Pencil icon to edit/add/remove the details for the selected vehicle. 

5. Fill in the mandatory(*) fields and click the Update Vehicle button.

Note: Repeat the steps for the remaining vehicles and ensure the vehicle names  are unique.